Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 429
network-type
Syntax network-type {sdh | sonet}
Context config>system>ptp
Supported
Platforms
7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE, 7210 SAS-T (network and access-uplink)
Description This command configures the codeset to be used for the encoding of QL values into PTP
clockClass values when the profile is configured for G.8265.1. The codeset is defined in
G.8265.1, Table 1.
This configuration only applies to the range of values observed in the clockClass values
transmitted out of the node in Announce messages. The 7210 SAS supports the reception of
any valid value in G.8265.1, Table 1.
Default sdh
Parameters sdh — Specifies the values used on a G.781 Option 1 compliant network.
sonet — Specifies the values used on a G.781 Option 2 compliant network.
peer
Syntax peer ip-address [create]
no peer ip-address
Context config>system>ptp
Supported
Platforms
7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE, 7210 SAS-T (network and access-uplink)
Description This command enables the context to configure parameters associated with remote PTP
peers.
Up to 20 remote PTP peers can be configured.
The no form of this command deletes the specified peer.
If the clock-type is ordinary slave or boundary, and PTP is not shut down, the last peer
cannot be deleted. This prevents the user from having PTP enabled without any peer
configured and enabled.
Parameters ip-address — Specifies the IPv4 address of the remote peer.
Values a.b.c.d
create — Keyword to create the peer.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English