Nokia 7210 SAS-M User Manual

System Management
428
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Supported
Platforms
7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE, 7210 SAS-T (network and access-uplink)
Description This command configures the PTP Announce interval.
The no form of this command reverts to the default value.
Default log-anno-interval 1
Parameters log-interval — Specifies the PTP Announce interval, specified as the logarithm to the
base 2, in seconds.
Values –3 to 4, where –3 = 0.125 s, –2 = 0.25 s, –1 = 0.5 s, 0 = 1 s, 1 = 2 s,
2 = 4 s, 3 = 8 s, 4 = 16 s
log-sync-interval
Syntax log-sync-interval values
no log-sync-interval
Context config>system>ptp
Supported
Platforms
7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE, 7210 SAS-T (network and access-uplink)
Description This command configures the message interval used for transmission of multicast
synchronization messages.
This command applies only if the profile is set to ieee1588-2008 or g8265dot1-2010. It does
not apply when g8275dot1-2014 is configured. When the profile is set to g8275dot1-2014,
the value is set to –4 (16 packets/s) and cannot be changed.
For multicast messages used on PTP Ethernet ports, this command configures the message
interval used for synchronization messages transmitted by the local node when the port is in
the master state.
The no form of this command reverts the message interval to the default value.
Default –6 (64 packets/s) for ieee1588-2008
–6 (64 packets/s) for g8265dot1-2010
–4 (16 packets/s) for g8275dot1-2014
Parameters values — Specifies the message interval, in log form.
Values –6 to –3, where –6 = 64 packets/s, –5 = 32 packets/s, –4 = 16
packets/s, –3 = 8 packets/s

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English