7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 427
If the PTP profile is changed, the domain is changed to the default domain for the new PTP
profile.
Default 0 for ieee1588-2008
4 for g8265dot1-2010
24 for g8275dot1-2014
Parameters domain — Specifies the PTP domain.
Values 0 to 255 for ieee1588-2008
0 to 255 for g8265dot1-2010
24 to 43 for g8275dot1-2014 (7210 SAS-M, 7210 SAS-Mxp,
7210 SAS-R6, 7210 SAS-R12)
local-priority
Syntax local-priority priority
Context config>system>ptp
config>system>ptp>peer
config>system>ptp>port
Supported
Platforms
7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE, 7210 SAS-T (network and access-uplink)
Description This command configures the local priority used to choose between PTP masters in the best
master clock algorithm (BMCA). This setting is relevant when the profile is set to g8265dot1-
2010 or g8275dot1-2014. The parameter is ignored when the profile is set to ieee1588-2008.
The value 1 is the highest priority and 255 is the lowest priority.
For g8265dot1-2010, this command sets the priority to select between master clocks with the
same quality.
For g8275dot1-2014, this command sets the value of the localPriority associated with the
Announce messages received from the external clocks (ptp>peer or ptp>port), or the local
clock (PTP).
Default 128
Parameters priority — Specifies the value of the local priority.
Values 1 to 255
log-anno-interval
Syntax log-anno-interval log-interval
no log-anno-interval
Context config>system>ptp
To Next Page
Loading...
Need help?
General
