Nokia 7210 SAS-M User Manual

System Management
426
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Default ptp
Parameters freq-source — Specifies whether PTP is used for frequency and time recovery or only for
time recovery. If ptp is specified, PTP is used for both frequency and time recovery.
If ssu is specified, PTP is used only for time recovery.
Values ptp, ssu
clock-type
Syntax clock-type boundary
clock-type ordinary slave
Context config>system>ptp
Supported
Platforms
7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE, 7210 SAS-T (network and access-uplink)
Description This command configures the type of clock. The clock-type can only be changed when PTP
is shutdown.
When changing the clock-type to or from a boundary clock on the 7210 SAS-R6,
7210 SAS-R12, 7210 SAS-Mxp, and 7210 SAS-T platforms, the node must be rebooted for
the change to take effect. Ensure that measures are taken to minimize service disruption
during the reboot process.
Default ordinary slave
Parameters boundary — Keyword to configure the clock as a boundary clock capable of functioning
as both a master and slave concurrently.
ordinary slave — Keyword to configure the clock as an ordinary PTP slave.
domain
Syntax domain domain
no domain
Context config>system>ptp
Supported
Platforms
7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE, 7210 SAS-T (network and access-uplink)
Description This command configures the PTP domain.
The no form of this command reverts to the default configuration.The default value is
dependent on the configured profile.
The domain cannot be changed unless PTP is shut down.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English