System Management
444
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
The no form of this command removes the specified day-of-month from the list.
Parameters day-number — Specifies the day. The positive integers specify the day of the month
counting from the first of the month. The negative integers specify the day of the
month counting from the last day of the month. For example, configuring day-of-
month -5, 5 in a month that has 31 days will specify the schedule to occur on the 27th
and 5th of that month.
Integer values must map to a valid day for the month in question. For example,
February 30 is not a valid date.
Values 1 to 31, -31 to -1 (maximum 62 day-numbers)
all — Specifies all days of the month.
end-time
Syntax end-time [date | day-name] time
[no] end-time
Context config>system>cron>sched
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command is used concurrently with type periodic or calendar. Using the type of
periodic, end-time determines at which interval the schedule will end. Using the type of
calendar, end-time determines on which date the schedule will end.
When no end-time is specified, the schedule runs forever.
Parameters date — Specifies the date to schedule a command.
Values YYYY:MM:DD in year:month:day number format
day-name — Specifies the day of the week to schedule a command.
Values sunday, monday, tuesday, wednesday, thursday, friday, saturday
time — Specifies the time of day to schedule a command.
Values hh:mm in hour:minute format
hour
Syntax hour {..hour-number [..hour-number] | all}
[no] hour
Context config>system>cron>sched
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
To Next Page
Loading...
Need help?
General
