7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 445
Description This command specifies which hour to schedule a command. Multiple hours of the day can
be specified. When multiple hours are configured, each of them will cause the schedule to
trigger. The day-of-month or weekday must also be specified. All days of the month or
weekdays can be specified. If an hour is configured without configuring the month, weekday,
day-of-month and minute commands, the event will not execute.
See the month, weekday, day-of-month, and minute commands for more information.
The no form of this command removes the specified hour from the configuration.
Parameters hour-number — Specifies the hour to schedule a command.
Values 0 to 23 (maximum 24 hour-numbers)
all — Specifies all hours.
interval
Syntax interval seconds
[no] interval
Context config>system>cron>sched
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command specifies the interval between runs of an event.
Parameters seconds — Specifies the interval, in seconds, between runs of an event.
Values 30 to 4,294,967,295
minute
Syntax minute {minute-number [..minute-number]| all}
[no] minute
Context config>system>cron>sched
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command specifies the minute to schedule a command. Multiple minutes of the hour can
be specified. When multiple minutes are configured, each of them will cause the schedule to
occur. If a minute is configured, but no hour or day is configured, the event will not execute.
If a minute is configured without configuring the month, weekday, day-of-month and hour
commands, the event will not execute.
See the month, weekday, day-of-month, and hour commands for more information.
To Next Page
Loading...
