System Management
458
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
The no form of this command removes the file location from the configuration. Scripts will not
execute if there is no result location defined.
Default no results
Parameters file-url — Specifies the location to send the CLI output from script runs. The file-url is a
location, directory, and filename prefix to which a data and timestamp suffix is added
when the results files are created during a script run, as follows:
file-url_YYYYMMDD-hhmmss.uuuuuu.out
where: YYYYMMDD — date
hhmmss — hours, minutes, and seconds
uuuuuu — microseconds (padded to 6 characters with leading zeros)
Values file-url — local-url | remote-url
local-url — [cflash-id/] [file-path]
255 chars maximum, including cflash-id
directory length 99 characters maximum each
remote url — [{ftp:// | tftp://}| login:password@remote-location/][file-
path]
255 characters maximum
directory length 99 characters maximum each
remote-location — [hostname | ipv4-address | ipv6-address]
ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x — 0 to FFFF (hexadecimal)
d — 0 to 255 (decimal)
interface — 32 characters maximum, for link
local addresses
cflash-id — cf1:
usb-flash-id — uf1:
System Time Commands
dst-zone
Syntax [no] dst-zone [std-zone-name | non-std-zone-name]
Context config>system>time
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
To Next Page
Loading...
