Nokia 7210 SAS-M - Page 457

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 457
lifetime
Syntax lifetime {seconds | forever}
Context config>system>script-control>script-policy
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command is used to configure the maximum length of time that a script may run.
Default lifetime 3600
Parameters seconds — Specifies the maximum amount of time that a script may run, in seconds.
Values 0 to 21474836
forever — Keyword to allow a script to run indefinitely.
max-completed
Syntax max-completed unsigned
Context config>system>script-control>script-policy
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables user to configure the maximum number of scripts to keep the run
history status entries.
Default max-completed 1
Parameters unsigned — Specifies the maximum number of script run history status entries to keep.
Values 1 to 1500
results
Syntax results file-url
no results
Context config>system>script-control>script-policy
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command specifies the location where the system writes the output of an event script’s
execution.