Nokia 7210 SAS-M - Page 456

System Management
456
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
x:x:x:x:x:x:d.d.d.d[-interface]
x — 0 to FFFF (hexadecimal)
d — 0 to 255 (decimal)
interface — 32 characters maximum, for link
local addresses
cflash-id — cf1:
usb-flash-id — uf1:
script-policy
Syntax [no] script-policy policy-name [owner policy-owner]
Context config>system>script-control
config>system>cron>schedule
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables the context to configure script policy parameters for a script.
Parameters policy-name — Specifies the name of the policy, up to 32 characters.
policy-owner — Specifies the name of the policy owner, up to 32 characters.
The owner is an arbitrary name and not necessarily a user name. Commands in the
scripts are not authorized against the owner.
Default “TiMOS CLI”
expire-time
Syntax expire-time {seconds | forever}
Context config>system>script-control>script-policy
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command is used to configure the maximum length of time to keep the run history status
entry from a script run.
Default expire-time 3600
Parameters seconds — Specifies the time to keep the run history status entry, in seconds.
Values 0 to 21474836
forever — Keyword to run the history status entry indefinitely.