Nokia 7210 SAS-M - Page 455

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 455
Context config>system>script-control>script-policy
config>system>script-control
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command is used to configure a script to be run.
The no form of this command removes the script.
Default no script
Parameters script-name — Specifies the name of the script, up to 32 characters.
script-owner — Specifies the name of the script owner, up to 32 characters.
The owner is an arbitrary name and not necessarily a user name. Commands in the
scripts are not authorized against the owner.
Default “TiMOS CLI”
location
Syntax location file-url
no location
Context config>system>script-control>script
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command is used to identify the location of a script to be scheduled.
The no form of this command removes the location.
Default no location
Parameters file-url — Specifies the location to search for scripts.
Values file-url — local-url | remote-url
local-url — [cflash-id/] [file-path]
255 chars maximum, including cflash-id
directory length 99 characters maximum each
remote url — [{ftp:// | tftp://}| login:password@remote-location/][file-
path]
255 characters maximum
directory length 99 characters maximum each
remote-location — [hostname | ipv4-address | ipv6-address]
ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x[-interface]