System Management
454
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
scheduler-policy
Syntax [no] scheduler-policy scheduler-policy-name [time-range time-range-name] [priority
priority]
Context config>system>cron>tod-suite>egress
config>system>cron>tod-suite>ingress
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command creates time-range based associations of previously created scheduler
policies. Multiple policies may be included and each must be assigned a different priority; in
case time-ranges overlap, the priority will be used to determine the prevailing policy. Only a
single reference to a policy may be included without a time-range.
Parameters scheduler-policy-name — Specifies a scheduler policy for this tod-suite, up to 32
characters.
time-range time-range-name — Specifies the name of the time-range, up to 32
characters. If the time-range is not populated the system will assume the assignment
to mean “all times”. Only one entry without a time-range is allowed for every type of
policy. The system does not allow the user to specify more than one policy and the
same time-range and priority.
priority priority — Specifies the time-range priority. Only one time-range assignment of
the same type and priority is allowed.
Values 1 to 10
Script Control Commands
script-control
Syntax script-control
Context config>system
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables the context to configure the script and script parameters.
script
Syntax script script-name [owner script-owner]
no script
To Next Page
Loading...
