System Management
460
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
end-month — Specifies the starting month of the year when the summer time will take
effect.
Values january, february, march, april, may, june, july, august, september,
october, november, december
Default january
hours — Specifies the hour at which the summer time will end.
Values 0 to 24
Default 0
minutes — Specifies the number of minutes, after the hours defined by the hours
parameter, when the summer time will end.
Values 0 to 59
Default 0
offset
Syntax offset offset
Context config>system>time>dst-zone
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command specifies the number of minutes that will be added to the time when summer
time takes effect. The same number of minutes will be subtracted from the time when the
summer time ends.
Parameters offset — Specifies the number of minutes added to the time at the beginning of summer
time and subtracted at the end of summer time, expressed as an integer.
Default 60
Values 0 to 60
start
Syntax start {start-week} {start-day} {start-month} [hours-minutes]
Context config>system>time>dst-zone
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures start of summer time settings.
To Next Page
Loading...
Need help?
General
