Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 465
Context config>system>sync-if-timing>bits2>input
config>system>sync-if-timing>bits2>output
Supported
Platforms
7210 SAS-T (network and access-uplink) and 7210 SAS-Mxp
Description This command administratively disables the entity. When disabled, an entity does not
change, reset, or remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities
contained within. Many objects must be shut down before they may be deleted.
The no form of this command places the entity into an administratively enabled state.
Default no shutdown
input
Syntax input
Context config>system>sync-if-timing>bits1
config>system>sync-if-timing>bits2
Supported
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6 and
7210 SAS-R12
Description This command enables the context to configure the external BITS timing reference input from
the node. The user has the option to enable or disable the BITS interface input independently
of each other.
output
Syntax output
Context config>system>sync-if-timing>bits1
Note:
• The 7210 SAS-R6 and 7210 SAS-R12 only support the configuration of the BITS1
interface for use as an input or output reference.
• The 7210 SAS-T and 7210 SAS-Mxp support the configuration of both BITS1 and
BITS2 interface as an input and output reference.
• On the 7210 SAS-T and 7210 SAS-Mxp, the BITS1 configuration parameters such as
bits-interface-type, line-length and source-reference are inherited for the BITS2
interface. CLI commands are available to administratively control the BITS2 interface,
allowing the user to shutdown or enable the BITS2 input and output independently of
the BITS1 interface.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English