System Management
464
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
shutdown
Syntax [no] shutdown
Context config>system>sync-if-timing>bits1>input
config>system>sync-if-timing>bits1>output
Supported
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6 and
7210 SAS-R12
Description This command administratively disables the entity. When disabled, an entity does not
change, reset, or remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities
contained within. Many objects must be shut down before they may be deleted.
The no form of this command places the entity into an administratively enabled state.
Default no shutdown
bits2
Syntax bits2
Context config>system>sync-if-timing
Supported
Platforms
7210 SAS-T (network and access-uplink) and 7210 SAS-Mxp
Description This command enables the context to configure parameters for the Building Integrated Timing
Supply (BITS).
shutdown
Syntax [no] shutdown
Note:
• The 7210 SAS-R6 and 7210 SAS-R12 only support the configuration of the BITS1
interface for use as an input or output reference.
• The 7210 SAS-T and 7210 SAS-Mxp support the configuration of both BITS1 and
BITS2 interface as an input and output reference.
• On the 7210 SAS-T and 7210 SAS-Mxp, the BITS1 configuration parameters such as
bits-interface-type, line-length, source-reference, and so on, are inherited for the
BITS2 interface. CLI commands are available to administratively control the BITS2
interface, allowing the user to shutdown or enable the BITS2 input and output
independently of the BITS1 interface.
To Next Page
Loading...
Need help?
General
