7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 489
If synchronization fails, alarms and log messages that indicate the type of error that caused
the failure of the synchronization operation are generated. When the error condition ceases
to exist, the alarm is cleared.
Only files stored on the router are synchronized. If a configuration file or image is stored in a
location other than on a local compact flash, the file is not synchronized; for example, storing
a configuration file on an FTP server.
The no form of this command removes the parameter from the configuration.
Default config
Parameters boot-env — Keyword to synchronize all files required for the boot process (loader, BOF,
images, and config).
config — Keyword to synchronize only the primary, secondary, and tertiary
configuration files.
multi-chassis
Syntax multi-chassis
Context config>redundancy
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document
Description This command enables the context to configure multi-chassis parameters.
peer-name
Syntax peer-name name
no peer-name
Context config>redundancy>multi-chassis>peer
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document
Description This command specifies a peer name.
Parameters name — Specifies the peer name, up to 32 characters. Any printable, seven-bit ASCII
characters can be used within the string. If the string contains special characters (#,
$, spaces, and so on), the entire string must be enclosed within double quotes.