7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 491
Context config>redundancy>multi-chassis>peer>sync
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document
Description This command specifies whether IGMP snooping information should be synchronized with
the multi-chassis peer.
Default no igmp-snooping
port
Syntax port port-id [sync-tag sync-tag] [create]
no port port-id
Context config>redundancy>multi-chassis>peer>sync
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document
Description This command specifies the port to be synchronized with the multi-chassis peer and a
synchronization tag to be used while synchronizing this port with the multi-chassis peer.
Parameters port-id — Specifies the port to be synchronized with the multi-chassis peer.
Values slot/mda/port or lag-id or pw-id
sync-tag — Specifies a synchronization tag, up to 32 characters, to be used while
synchronizing this port with the multi-chassis peer.
create — Keyword to create an entry.
range
Syntax range encap-range sync-tag sync-tag
no range encap-range
Context config>redundancy>multi-chassis>peer>sync>port
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document
Description This command configures a range of encapsulation values.
Parameters encap-range — Specifies a range of encapsulation values on a port to be synchronized
with a multi-chassis peer.
Values dot1q — start-qtag-end-qtag
start-qtag — 0 to 4094
end-qtag — 0 to 4094
To Next Page
Loading...
