7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 507
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the time before reinitializing LLDP on a port.
Parameters time — Specifies the time, in seconds, before reinitializing LLDP on a port.
Values 1 to 10
Default 2
tx-credit-max
Syntax tx-credit-max count
no tx-credit-max
Context config>system>lldp
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the maximum consecutive LLDPDUs transmitted.
Parameters count — Specifies the maximum consecutive LLDPDUs transmitted.
Values 1 to 100
Default 5
tx-hold-multiplier
Syntax tx-hold-multiplier multiplier
no tx-hold-multiplier
Context config>system>lldp
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the multiplier of the tx-interval.
Parameters multiplier — Specifies the multiplier of the tx-interval.
Values 2 to 10
Default 4
To Next Page
Loading...
