Nokia 7210 SAS-M - Page 506

System Management
506
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Parameters time — Specifies the fast transmission period, in seconds.
Values 1 to 3600
Default 1
message-fast-tx-init
Syntax message-fast-tx-init count
no message-fast-tx-init
Context config>system>lldp
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the number of LLDPDUs to send during the fast transmission
period.
Parameters count — Specifies the number of LLDPDUs to send during the fast transmission period.
Values 1 to 8
Default 4
notification-interval
Syntax notification-interval time
no notification-interval
Context config>system>lldp
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the minimum time between change notifications.
Parameters time — Specifies the minimum time, in seconds, between change notifications.
Values 5 to 3600
Default 5
reinit-delay
Syntax reinit-delay time
no reinit-delay
Context config>system>lldp