Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 509
Parameters bridge-mac — Specifies destination bridge MAC type to use by LLDP.
Values nearest-bridge — Specifies to use the nearest bridge
nearest-non-tpmr — Specifies to use the nearest non-Two-Port
MAC Relay (TPMR)
nearest-customer — Specifies to use the nearest customer
admin-status
Syntax admin-status {rx | tx | tx-rx | disabled}
Context config>port>ethernet>lldp>dstmac
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command specifies the administratively desired status of the local LLDP agent.
Parameters rx — Specifies that the LLDP agent will receive, but will not transmit LLDP frames on this
port.
tx — Specifies that the LLDP agent will transmit LLDP frames on this port and will not
store any information about the remote systems connected.
tx-rx — Specifies that the LLDP agent will transmit and receive LLDP frames on this port.
disabled — Specifies that the LLDP agent will not transmit or receive LLDP frames on
this port. If there is remote systems information which is received on this port and
stored in other tables, before the port's admin status becomes disabled, the
information will naturally age out.
notification
Syntax [no] notification
Context config>port>ethernet>lldp>dstmac
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command enables LLDP notifications.
The no form of this command disables LLDP notifications.
tx-mgmt-address
Syntax tx-mgmt-address [system]
no tx-mgmt-address

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English