Nokia 7210 SAS-M User Manual

System Management
512
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
Default no enable-bgp3107-frr
enable-ldporsvp-frr
Syntax enable-ldporsvp-frr
no enable-ldporsvp-frr
Context config>system>resource-profile
Supported
Platforms
7210 SAS-M, 7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, and 7210 SAS-Sx 10/
100GE
Description This command enables the allocation of MPLS FIB and protection group resources required
for enabling uniform FRR for LDP-over-RSVP LSPs (LDP FECs resolved using RSVP-TE
LSPs). This is a per-node configuration and enabling the command affects all LDP-over-
RSVP LSPs.
The no form of this command disables the use of uniform FRR for LDP-over-RSVP LSPs.
Default no enable-ldporsvp-frr
g8032-fast-flood-enable
Syntax [no] g8032-fast-flood-enable
Context configure>system>resource-profile (7210 SAS-M)
configure>system>resource-profile>ingress-internal-tcam (7210 SAS-T)
Supported
Platforms
7210 SAS-M and 7210 SAS-T
Description This command configures the G.8032 fast-flood feature. When this command is executed, it
is stored in the configuration file after admin save is executed. A system reboot is required
for this command to take effect.
It is recommended to enable this command to improve service failover time due to failures in
the ring path. When fast flood is enabled, on failure detection in one of the paths of the ETH-
ring, along with MAC flush, the system starts to flood the traffic on-to the available path.
Caution: If the command is enabled, the amount of resources required is twice the amount
required without uniform FRR, and the number of LDP-over-RSVP LSPs that can be
accommodated in the MPLS FIB is therefore halved if uniform FRR is enabled. Ensure that
sufficient MPLS resources are available to accommodate all required LDP-over-RSVP
LSPs before using this command.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English