7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 517
Per SAP Egress Aggregate Meter, Egress ACLs (all of IPv4, IPv6, and MAC match-
criteria), and MAC authentication
• 7210 SAS-T network mode
Per SAP Egress Aggregate meter, Egress ACLs (all of IPv4, IPv6, and MAC match-
criteria), and MAC authentication
• 7210 SAS-Mxp mode
Egress ACLs (all of IPv4, IPv6, and MAC match-criteria) and MAC authentication
• 7210 SAS-Sx 1/10GE mode (standalone and standalone-VC)
Per SAP Egress Aggregate meter, Egress ACLs (all of IPv4, IPv6, and MAC match-
criteria), and MAC authentication
• 7210 SAS-S 1/10GE mode (standalone and standalone-VC)
Per SAP Egress Aggregate meter, Egress ACLs (all of IPv4, IPv6, and MAC match-
criteria), and MAC authentication
• 7210 SAS-Sx 10/100GE mode
Per SAP Egress Aggregate meter and Egress ACLs (all of IPv4, IPv6, and MAC match-
criteria)
• 7210 SAS-R6 IMMv1, IMMv2, and IMM-c
Per SAP Egress Aggregate meter, Egress ACLs (all of IPv4, IPv6, and MAC match-
criteria), Ethernet CFM (bi-directional MIP), and MAC authentication
• 7210 SAS-R12 IMMv1, IMMv2, and IMM-c
Per SAP Egress Aggregate meter and Egress ACLs (all of IPv4, IPv6, and MAC match-
criteria), Ethernet CFM (bi-directional MIP)
acl-sap-egress
Syntax acl-sap-egress [num-resources]
no acl-sap-ingress
Note:
• In some scenarios, reassigning a chunk of resources among features may require the
node to be rebooted. See the CLI description of the feature for detailed information.
• The egress internal TCAM pool of resources is available per node on the 7210 SAS-M,
7210 SAS-T, 7210 SAS-Sx/S 1/10GE (standalone), 7210 SAS-Sx 10/100GE, and
7210 SAS-Mxp. On the 7210 SAS-Sx/S 1/10GE (standalone-VC), 7210 SAS-R6, and
7210 SAS-R12, it is available as a per-IMM pool of resources.
• It is possible to configure a resource profile per node or per card in a virtual chassis.
• The number of chunks and the number of resources per chunk varies for the 7210 SAS
platforms. Contact your Nokia technical support representative for more information.
• To be enabled, some features require the allocation of a specific number of chunks
(greater than 1). If the minimum number of chunks is not assigned, the system cannot
allocate the required resources to the feature, which causes the command associated
with the feature to fail.