7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 533
Note:
1. IMMv1 and IMM-c cards cannot be installed in the same 7210 SAS-R6 chassis. IMMv1 cards are
not supported on the 7210 SAS-R12.
acl-sap-ingress
Syntax acl-sap-ingress [num-resources]
no acl-sap-ingress
Context configure>system>resource-profile>ingress-internal-tcam
7210 SAS-S 1/10GE
(standalone-VC)
• SAP ingress QoS classification (IPv4 and IPv6 match-
criteria)
• Ingress ACLs (all of IPv4, IPv6, and MAC match-criteria)
• Ethernet CFM Up MEP, SAP Down MEP, SDP Down MEP,
ingress MIP
• SAP ingress aggregate meter
• MAC authentication
7210 SAS-Sx 10/
100GE
• SAP ingress QoS classification (IPv4 and IPv6 match-
criteria)
• Ingress ACLs (all of IPv4, IPv6, and MAC match-criteria)
• Ethernet CFM Up MEP, Down MEP
Table 49 Ingress Internal TCAM Resource Sharing (Platforms and
Features) (Continued)
Platform Features Sharing Ingress Internal TCAM Resource Pool
Note:
• In some scenarios, reassigning a chunk of resources among features may require the
node to be rebooted. See the CLI description of the specific feature for more
information.
• The ingress internal TCAM pool of resources is available per node on the 7210 SAS-M,
7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE (standalone), and
7210 SAS-Sx 10/100GE. On the 7210 SAS-Sx/S 1/10GE (standalone-VC),
7210 SAS-R6, and 7210 SAS-R12, it is available as a per-IMM pool of resources.
• The number of chunks and the number of resources per chunk varies among the
different platforms. Contact your Nokia technical support representative for more
information.
• To be enabled, some features require the allocation of a specific number of chunks
(greater than 1). If the minimum number of chunks is not assigned, the system cannot
allocate the required resources to the feature, which causes the command associated
with the feature to fail.
To Next Page
Loading...
Need help?
General
