System Management
574
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 16132 AAAB TQZZA Edition: 01
• On IMMv2, resources are used to implement the G8032 fast-flood mechanism for only
RVPLS services. These resources are used only if G8032 is enabled for RVPLS
services. The G8032 fast-flood mechanism is also implemented for VPLS services, but
no user configuration is required and it does not need resources to be allocated from the
sf-ingress-internal-tcam pool.
Parameters max_slice — Specifies the number of slices to be allocated for the G8032 fast-flood
mechanism. Each slice has many resource entries that are used to implement G8032
fast flood for multiple data services protected by G8032.
Values 1 to 7
mpls-p2mp
Syntax mpls-p2mp max_slices
no mpls-p2mp
Context config>system>glob-res-profile>sf-ingress-internal-tcam
Supported
Platforms
7210 SAS-R6 and 7210 SAS-R12
Description This command allows the user to configure the resources to be used for NG-MVPN P2MP
LSPs. The users must allocate some resources using the command before configuring NG-
MVPN. It might be necessary to free up resources allocated to other features to allocate
resources for it.
On 7210 SAS-R6, the number of resources per slice/chunk varies. Hence, the number of
resources allocated to a feature varies based on the order of allocation of resources among
different features. It might be necessary to allocate more slices to a feature to achieve desired
scaling.
The no form of this command does not allocate any resources for use by P2MP LSPs used
with NG-MVPN feature. If no resources are allocated for use, the software will not be able to
setup P2MP LSPs for use with NG-MVPN.
Parameters max_slice — Specifies the number of slices to be allocated for NG-MVPN P2MP LSPs.
Values 0 to 3
Default 1
To Next Page
Loading...
