Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
Edition: 01 3HE 16132 AAAB TQZZA 573
eth-cfm-upmeps
Syntax eth-cfm-upmeps max_slices
no eth-cfm-upmeps
Context config>system>glob-res-profile>sf-ingress-internal-tcam
Supported
Platforms
7210 SAS-R6 and 7210 SAS-R12
Description This command allocates resources towards UP MEP from the sf-ingress-internal-tcam pool.
The value specified here allocates a fixed number of entries for use with this feature. Entries
are allocated by software from this pool whenever UP MEP is configured in a VPLS service
(either on a SAP or a SDP). The number of entries required per MEP depends on the level of
the MEP.
The no form of this command does not allocate any resources for use by CFM UP MEPs. If
no resources are allocated for use, the software fails all attempts to configure an UP MEP.
Parameters max_slices — Specifies the number of slice to be allocated for VPLS UP MEP feature.
Each slice has many resource entries which is used to identify and process VPLS UP
MEP messages.
Values 0 to 6
g8032-fast-flood
Syntax g8032-fast-flood max_slices
no g8032-fast-flood
Context config>system>glob-res-profile>sf-ingress-internal-tcam
Supported
Platforms
7210 SAS-R6 and 7210 SAS-R12
Description This command configures the amount of ingress internal CAM resources available in the SF/
CPM for use by G8032 fast-flood mechanism. These are used to implement G8032 fast-flood
for data services protected using G8032 ring protection mechanism. The amount of slices
determines the amount of data services that can be protected by G8032 and use the fast-
flood mechanism to reduce the convergence time on a ring failure and switchover.
The difference between resource usage on IMMv1 and IMMv2 is described as follows.
• On IMMv1, resources are used to implement the G8032 fast-flood mechanism for both
VPLS services and RVPLS services.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English