7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Appendix: 7210 SAS Boot Procedures
Edition: 01 3HE 16132 AAAB TQZZA 691
Current configuration enables use of console (setting is "no console-disabled")
Press ENTER to proceed with existing setting or 'disable' to disable console access
:
Step 9. At the prompt, press Enter. The following console output is displayed.
New Settings
------------
primary-image cf2:/both.tim
primary-config uf1:/sassx64.cfg
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/65
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 100000
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/66
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 100000
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
Do you want to overwrite cf1:/bof.cfg with the new settings? (yes/no):
Step 10. At the prompt, enter yes. The 7210 SAS device begins to boot with the new
settings. The following console output is displayed.
Successfully saved the new settings in cf1:/bof.cfg
Configuring Network with uplinkA Port Setting.....
Primary config file present at: uf1:/sassx64.cfg
Skipping missing or bad Sap index file 'uf1:/sassx64.sdx'
Primary image location: cf2:/both.tim
Loading image cf2:\both.tim
Version B-20.3.B1-1, Wed Feb 12 15:33:08 IST 2020 by sasbuild in /home/sasbuild/
20.3B1/panos/main
text:(41664192-->183719312) + data:(7133216-->49945144)
Executing TiMOS image at 0x2800000
Step 11. After the 7210 SAS device boots up, the following login prompt is
displayed.
All rights reserved. All use subject to applicable license agreements.
Built on Wed Apr 20 14:32:04 IST 2011 by builder in /builder/3.0B5/panos/main
Login:
To Next Page
Loading...
Need help?
General
