Nokia 7210 SAS-M User Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
CLI Usage
Edition: 01 3HE 16132 AAAB TQZZA 85
sap
Syntax sap sap-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>service>id
Supported
Platforms
Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command monitors statistics for a SAP associated with this service.
This command displays statistics for a specific SAP, identified by the port-id and
encapsulation value, at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the SAP. The subsequent statistical
information listed for each interval is displayed as a delta to the previous display. When the
keyword rate is specified, the rate per second for each statistic is displayed instead of the
delta.
Monitor commands are similar to show commands but only statistical information displays.
Monitor commands display the selected statistics according to the configured number of
times at the interval specified.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition.
Values sap-id:null[port-id | lag-id]
dot1q [port-id | lag-id]:* | qtag
qinq [port-id | lag-id]:qtag1.qtag2
port-id slot/mda/port
lag-idlag-id
lag keyword
id1 to 200
qtag10 to 4094
qtag2 *, 0 to 4094
dlci 16 to 022
port-id — Specifies the physical port ID in the slot/mda/port format.
If the card in the slot has Media Dependent Adapters (MDAs) installed, the port-id
must be in the slot_number/MDA_number/port_number format. For example 1/2/3
specifies port 3 on MDA 2 in slot 1.
qtag1, qtag2 — Specifies the encapsulation value used to identify the SAP on the port or
sub-port. If this parameter is not specifically defined, the default value is 0.
The values depends on the encapsulation type configured for the interface. The
following table describes the allowed values for the port and encapsulation types.
Table 16 Allowed Values for Port and Encapsulation Types
Port Type Encap-Type Allowed Values Comments
Ethernet Null 0 The SAP is identified by the port.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English