Nokia 7368 ISAM ONT G-240W-J - Page 113

7368 ISAM ONT G-240W-J Product Guide Configure a G-240W-J indoor ONT
Issue: 01 3FE-48009-AAAA-TCZZA 113
WAN Interface
Choose a WAN interface from the drop-down menu.
GRE tunnels can only be created on HSI-enabled WAN interfaces.
Primary Remote End
Secondary Remote End
(optional)
Enter an IP address or FQDN that is unique in the system.
If the primary remote endpoint is down or unreachable, the secondary
remote endpoint becomes active, if configured.
The secondary remote endpoint remains active until it becomes
unreachable, in which case the primary remote endpoint becomes active
again. Revertive mode is not supported.
If both endpoints are unreachable, the GRE tunnel is declared down.
Connected Remote End
This field displays the current data traffic path for the GRE tunnel.
Failover mechanism
This feature is automatically selected by the system.
Traffic timeout to start pings
Enter the traffic timeout in seconds (0 to 100).
No. of retries before unreachable
Enter the number of retries before the tunnel is declared down (2 to
1024).
Procedure 26 QoS configuration
1 Select Network > QoS Config from the top-level menu in the Home Gateway window.
Figure 42 shows the window for configuring QoS L2 (Layer 2 packet sizes).
2
Configure the GRE tunnel by entering or selecting the required information.
3
Click Save.
4
STOP. This procedure is complete.
(2
of
2)