7368 ISAM ONT G-240W-J Product Guide Install a G-240W-J indoor ONT
Issue: 01 3FE-48009-AAAA-TCZZA 63
• voltmeter or multimeter
• optical power meter
• drill and drill bits
• paper clip
6.5 Safety information
Read the following safety information before installing the unit.
Danger 1 — Hazardous electrical voltages and currents can cause
serious physical harm or death. Always use insulated tools and
follow proper safety precautions when connecting or disconnecting
power circuits.
Danger 2 — Make sure all sources of power are turned off and
have no live voltages present on feed lines or terminals. Use
a voltmeter to measure for voltage before proceeding.
Danger 3 — Always contact the local utility company before connecting
the enclosure to the utilities.
Warning — This equipment is ESD sensitive. Proper ESD
protections should be used when removing the fiber access cover
of the indoor ONT.
Caution — Keep indoor ONTs out of direct sunlight. Prolonged exposure
to direct sunlight can damage the unit.
Note 1 — Observe the local and national laws and regulations that
may be applicable to this installation.
Note 2 — Observe the following:
• The indoor ONT should be installed in accordance with the
applicable requirements of the NEC or CEC. Local authorities
and practices take precedent when there is conflict between the
local standard and the NEC or CEC.
• The indoor ONT must be installed by qualified service personnel.
• Indoor ONTs must be installed with cables that are suitably rated
and listed for indoor use.
To Next Page
Loading...
