Install a G-240W-J indoor ONT 7368 ISAM ONT G-240W-J Product Guide
64 3FE-48009-AAAA-TCZZA Issue: 01
• See the detailed specifications in the G-240W-J unit data sheet
for the temperature ranges for these ONTs.
6.6 Procedure
Use this procedure to install a G-240W-J indoor ONT.
1 Place the indoor ONT unit:
a On a flat surface, such as a desk; go to step 3.
Note — The G-240W-J cannot be stacked with another ONT or with other
equipment. The ONT mounting requirements are:
• allow a minimum 100 mm clearance above the top cover
• allow a minimum 50 mm clearance from the side vents
• do not place any heat source directly above the top cover or below the bottom
cover
b On a wall; go to step
Mount the G-240W-J indoor ONT to a wall.
The G-240W-J indoor ONT must be mounted in a horizontal position, as indicated by the
wall mounting key holes in Figure 16.
Figure 16 shows the ONT with the connections and the key mounting holes.
To Next Page
Loading...
