Nokia 7368 ISAM ONT G-240W-J - Page 66

Install a G-240W-J indoor ONT 7368 ISAM ONT G-240W-J Product Guide
66 3FE-48009-AAAA-TCZZA Issue: 01
6 Connect the fiber optic cable with SC/APC adapter into the SC/APC
connector; see Figure 16 for the location of the SC/APC connector.
7 Install the power supply according to manufacturer specifications.
Note — Observe the following:
• Units must be powered by a Listed or CE approved and marked limited
power source power supply with a minimum output rate of 12 VDC, 3 A.
8 Connect the power cable to the power connector.
9 Power up the ONT unit by using the power switch.
10 If used, enable the Wi-Fi service.
i Locate the WLAN button; see Figure 16 for the location of the WLAN button. ii
Press the WLAN button to change the status of the Wi-Fi service.
11 If used, enable the WPS.
i Locate the WPS button; see Figure 16 for the location of the WPS button. ii
Press the WPS button to change the status of the WPS.
12 Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368 Hardware and
Cabling Installation Guide.
Danger —
Fiber cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning —
Be careful to maintain a bend radius of no less than 1.5in.
(3.8
cm) when connecting the fiber optic cable. Too small of a bend radius
in the cable can result in damage to the optic fiber.
Note —
Fiber cable preparation varies depending on the type and size
of the inside or outside plant fiber cable being spliced to the SC/APC fiber
optic pigtail cable.