Nokia 7368 ISAM ONT G-240W-J - Page 94

Configure a G-240W-J indoor ONT 7368 ISAM ONT G-240W-J Product Guide
94 3FE-48009-AAAA-TCZZA Issue: 01
Port Mode
All Ports to Bridge Mode
Select this checkbox to set all ports to Bridge mode
Port 1 - 4
Drop-down port mode for each port: Route mode or Bridge mode
IPv4 Address
IP Address of the ONT
Subnet Mask
Subnet mask of the ONT
DHCP Enable
Select this checkbox to enable DHCP
DHCP Start IP Address
Starting DHCP IP address
(1 of 2)
Field
Description
DHCP End IP Address
Ending DHCP IP address
DHCP Lease Time
DHCP lease time (in min)
Primary DNS
Primary DNS identifier
Secondary DNS
Secondary DNS identifier
Static DHCP Entry
MAC Address
MAC address for the static DHCP
IPv4 Address
IPv4 address for the static DHCP
(2 of 2)
2 Select the mode for each port.
3 Click Save.
4 Enter the DHCP configuration information.
5 Click Save.
6 Enter the Static DHCP information.
7 Click Add.
You can also use this panel to delete a Static DHCP MAC address or IPv4 address.
8 STOP. This procedure is complete.