Nokia 7368 ISAM ONT G-240W-J - Page 99

7368 ISAM ONT G-240W-J Product Guide Configure a G-240W-J indoor ONT
1
Issue: 01 3FE-48009-AAAA-TCZZA 99
Connection Type
Choose a connection type: IPoE or PPPoE
IP mode
Choose an IP mode from the drop-down menu: IPv4 or IPv6
Enable/Disable
Select this checkbox to enable the WAN connection
NAT
Select this checkbox to enable NAT
Service
Select the checkboxes to enable service types for this connection
Enable VLAN
Select this checkbox to enable VLAN
VLAN ID
Enter the VLAN ID
VLAN PRI
Enter the VLAN PRI
WAN IP Mode
Choose an IP mode from the drop-down menu
Connection Trigger
Choose a connection trigger from the drop-down menu; for example, AlwaysOn
The Connection Trigger field is visible when the IP mode is set to IPv6 or
IPv4&IPv6.
Username
Enter the username
Password
Enter the password
Keep Alive Time
Enter the Keep Alive Time (from 5 to 60 seconds)
Keep Alive Retry
The number of keep alive time retires (1 to 10); this field cannot be modified in regular
user mode
Echo Value
The echo value: the keep alive time value multiplied by the number of retries; this
field cannot be modified in regular user mode
Manual DNS
If desired, enter a manual DNS
DHCPv6 Enable
Select this checkbox to enable the DHCPv6 function on this WAN interface
Request Address
Select this checkbox to enable the DHCPv6 option to request the Address from the
DHCPv6 Server
Request Prefix
Select this checkbox to enable the DHCPv6 option to request the Prefix from the
DHCPv6 server
Request Option
Enter the custom DHCPv6 option send to the DHCPv6 server
Auto Configured Enable
Select this checkbox to enable the Auto Configuration function on this WAN
interface
2 Configure a specific WAN connection.
3 Click Save.