SNMP
198
System Management Guide
3HE 11018 AAAC TQZZA Edition: 01
4.5 SNMP Configuration Overview
This section describes how to configure SNMP components that apply to SNMPv1,
SNMPv2c, and SNMPv3 on the 7705 SAR.
• Configuring SNMPv1 and SNMPv2c
• Configuring SNMPv3
4.5.1 Configuring SNMPv1 and SNMPv2c
The 7705 SAR router is based on SNMPv3. To use 7705 SAR routers with SNMPv1
and/or SNMPv2c, SNMP community strings must be configured. Three predefined
access methods are available when SNMPv1 or SNMPv2c access is required. Each
access method (r, rw, or rwa) is associated with an SNMPv3 access group that
determines the access privileges and the scope of managed objects available. The
community command is used to associate a community string with a specific access
method and the required SNMP version (SNMPv1 or SNMPv2c). The access
methods are:
• read-only — grants read-only access to the entire management structure with
the exception of the security area
• read-write — grants read and write access to the entire management structure
with the exception of the security area
• read-write-all — grants read and write access to the entire management
structure, including security
If the predefined access groups do not meet your access requirements, then
additional access groups and views can be configured. The usm-community
command is used to associate an access group with an SNMPv1 or SNMPv2c
community string.
SNMP trap destinations are configured in the config>log>snmp-trap-group
context.
To Next Page
Loading...
