Nokia 7705 - 3.9.11.2 Configuring RADIUS Authorization

Security
64
System Management Guide
3HE 11018 AAAC TQZZA Edition: 01
security>radius# server 4 address 10.10.0.3 secret test4
security>radius# retry 5
security>radius# timeout 5
config>system>security>radius# exit
The following example displays the RADIUS authentication configuration:
ALU-1>config>system>security# info
----------------------------------------------
retry 5
timeout 5
server 1 address A:A:A:A:A:A:A:1 secret "test1"
server 2 address 10.10.0.1 secret "test2"
server 3 address 10.10.0.2 secret "test3"
server 4 address 10.10.0.3 secret "test4"
...
----------------------------------------
ALU-1>config>system>security#
3.9.11.2 Configuring RADIUS Authorization
In order for RADIUS authorization to function, RADIUS authentication must be
enabled first. See Configuring RADIUS Authentication.
In addition to the local configuration requirements, VSAs must be configured on the
RADIUS server. See Vendor-Specific Attributes (VSAs).
On the local router, use the following CLI commands to configure RADIUS
authorization:
CLI Syntax: config>system>security
radius
authorization
The following example displays the CLI syntax usage:
Example: config>system>security>
config>system>security# radius
config>system>security>radius# authorization
The following example displays the RADIUS authorization configuration:
ALU-1>config>system>security# info
----------------------------------------------
...
radius
authorization
retry 5
timeout 5