Security
26
System Management Guide
3HE 11018 AAAC TQZZA Edition: 01
3.2 Security Controls
You can configure the 7705 SAR to use RADIUS, TACACS+, and local
authentication to validate users requesting access to the network. The order in which
password authentication is processed among RADIUS, TACACS+ and local
passwords can be specifically configured. For example, the authentication order can
be configured to process authorization via TACACS+ first, then RADIUS for
authentication and accounting. Local access can be specified next in the
authentication order in the event that the RADIUS and TACACS+ servers are not
operational.
3.2.1 When a Server Does Not Respond
A trap is issued if a RADIUS server is unresponsive. An alarm is raised if RADIUS is
enabled with at least one RADIUS server and no response is received to either
accounting or user access requests from any server.
Periodic checks to determine if the primary server is responsive again are performed.
If a server is down, it will not be contacted for 5 minutes. If a login is attempted after
5 minutes, then the server is contacted again. If a server has the health check feature
enabled and is unresponsive, the server’s status is checked every 30 seconds.
Health check is enabled by default. When a service response is restored from at least
one server, the alarm condition is cleared. Alarms are raised and cleared on the
Nokia Fault Manager or other third party fault management servers.
The servers are accessed in order from lowest to highest specified index (from 1 to
5) for authentication requests until a response from a server is received. A higher
indexed server is only queried if no response is received from a lower indexed server.
If a response from the server is received, no other server is queried.
3.2.2 Access Request Flow
In Figure 2, the authentication process is defined in the config>system>security>
password context. The authentication order is determined by specifying the
sequence in which password authentication is attempted among RADIUS,
TACACS+, and local servers.