System Management Guide Event and Accounting Logs
Edition: 01 3HE 11018 AAAC TQZZA 301
Default Each event has a default suppress or generate state. To display a list of all events and the
current configuration use the event-control command.
Parameters application-id — the application whose events are affected by this event control filter
Values A valid application name. To display a list of valid application names,
use the applications command. Valid applications are:
aps, atm, bgp, chassis, debug, dhcp, dhcps, efm_oam, eth_cfm,
filter, firewall, igmp, igmp_snooping, ip, ipsec, isis, lag, ldp, lldp,
logger, mcpath, mc_redundancy, mirror, mld, mld_snooping, mpls,
mwmgr, ntp, oam, ospf, pim, pim_snooping, port, ppp, ptp, radius,
rip, rip_ng, route_policy, rsvp, security, snmp, stp, svcmgr, system,
tss, user, vrrp, vrtr
Default none; this parameter must be explicitly specified
event-name | event-number — to generate, suppress, or revert to default for a single
event, enter the specific number or event short name. If no event number or name is
specified, the command applies to all events in the application. To display a list of all
event short names use the show>log>event-control command.
Values event name: 32 characters, maximum
event number: 0 to 4294967295
Default n/a
generate — specifies that a logger event is created when this event occurs. The
generate keyword can be used with two optional parameters: severity-level and
throttle.
Default generate
severity-level — An ASCII string representing the severity level to associate with the
specified generated events
Values one of: cleared, indeterminate, critical, major, minor, warning
Default the system-assigned severity level
throttle — specifies whether events of this type will be throttled
Default By default, event throttling is off for each specific event type. It must
be explicitly enabled for each event type where throttling is desired.
This makes backwards compatibility easier to manage.
suppress — indicates that the specified events will not be logged. If the suppress
keyword is not specified, then the events are generated by default.
Default generate
To Next Page
Loading...
