Nokia 7705 - Page 90

Security
90
System Management Guide
3HE 11018 AAAC TQZZA Edition: 01
The no form of the command removes the specified source address from the application,
causing the application to use the system IP address as the source address.
Parameters app — specifies the application name
Values telnet, ftp, ssh, radius, tacplus, snmptrap, syslog, ping, traceroute,
dns, sntp, ntp
ip-int-name | ip-address — specifies the name of the IP interface or IPv4 address. If the
string contains special characters (#, $, spaces, etc.), the entire string must be
enclosed within double quotes.
application6
Syntax application6 app ipv6-address
no application6 app
Context config>system>security>source-address
Description This command specifies the application to use the source IPv6 address specified by the
source-address command.
The no form of the command removes the specified source address from the application,
causing the application to use the system IP address as the source address.
Parameters app — specifies the application name
Values dns, ftp, ssh, ntp, ping, radius, snmptrap, syslog, tacplus, telnet,
traceroute
ipv6-address — specifies the IPv6 address
telnet-server
Syntax [no] telnet-server
Context config>system>security
Description This command enables Telnet servers running on the system.
Telnet servers are off by default. At system startup, only SSH servers are enabled.
Telnet servers in 7705 SAR networks limit a Telnet client to three retries to log in. The Telnet
server disconnects the Telnet client session after three retries.
The no form of the command disables Telnet servers running on the system.
Default no telnet-server