To edit the PIN codes for the security module, open the
module, and select Module PIN to edit the PIN code for
the security module or Signing PIN to edit the PIN code
for digital signatures. You may not be able to change
these codes for all security modules.
The key store contains the contents of the security
module. To delete the key store, select Options >
Delete. You may not be able to delete the key store of
all security modules.
Remote configuration
Select Menu > Control panel > Phone > Device
mgr..
With Device manager, you can manage settings, data,
and software on your device remotely.
You can connect to a server, and receive configuration
settings for your device. You may receive server profiles
and different configuration settings from your service
providers or company information management
department. Configuration settings may include
connection and other settings used by different
applications in your device. The available options may
vary.
The remote configuration connection is usually started
by the server when the device settings need to be
updated.
To create a new server profile, select Options >
Server profiles > Options > New server profile.
You may receive these settings from your service
provider in a configuration message. If not, define the
following:
• Server name — Enter a name for the configuration
server.
• Server ID — Enter the unique ID to identify the
configuration server.
• Server password — Enter a password to identify
your device to the server.
• Session mode — Select the preferred connection
type.
• Access point — Select the access point to use for
the connection, or create a new access point. You
can also choose to be asked for the access point
every time you start a connection. This setting is
available only if you have selected Internet as the
bearer type.
• Host address — Enter the web address of the
configuration server.
• Port — Enter the port number of the server.
• User name and Password — Enter your user ID and
password for the configuration server.
• Allow configuration — Select Yes to allow the
server to initiate a configuration session.
• Auto-accept all requests — Select Yes if you do
not want the server to ask for your confirmation
when it initiates a configuration session.
• Network authentication — Select whether to use
http authentication.
• Network user name and Network
password — Enter your user ID and password for
the http authentication. This setting is available
only if you have selected Network
authentication to be used.
To connect to the server and receive configuration
settings for your device, select Options > Start
configuration.
140
Security and data management
To Next Page
Loading...
