Nokia E75 - Access Points; Create a New Access Point; Create Access Point Groups

• Video sharing — Enable video sharing, select the
SIP profile for video sharing, and define the video
saving settings.
• SIP settings — View or create session initiation
protocol (SIP) profiles.
• XDM settings — Create an XDM profile. The XDM
profile is required for many communications
applications, for example, presence.
• Presence — Edit the settings for presence (network
service). To register for the service, contact your
service provider.
• Remote drives — Connect the device to a remote
drive.
• Configurations — View and delete trusted servers
from which your device may receive configuration
settings.
• APN control — Restrict packet data connections.
Access points
Create a new access point
Select Menu > Control panel > Settings and
Connection > Destinations.
You may receive access point settings in a message
from a service provider. Some or all access points may
be preset for your device by your service provider, and
you may not be able to change, create, edit, or remove
them.
When you select one of the access point groups (
,
, , , ), you can see the access point types:
indicates a protected access point
indicates a packet data access point
indicates a wireless LAN (WLAN) access point
Tip: You can create internet access points in a
WLAN with the WLAN wizard.
To create a new access point, select
Access point.
The device asks to check for available connections.
After the search, connections that are already available
are displayed and can be shared by a new access point.
If you skip this step, you are asked to select a
connection method and to define the settings needed.
To edit the settings of an access point, select one of the
access point groups, scroll to an access point, and select
Edit. Use the instructions provided by your service
provider to edit the following:
• Connection name — Enter a name for the
connection.
• Data bearer — Select the data connection type.
Depending on the data connection you select, only
certain setting fields are available. Fill in all fields
marked with Must be defined or with a red *. Other
fields can be left empty, unless your service provider
has instructed otherwise.
To use a data connection, your service provider must
support this feature, and if necessary, activate it for
your SIM card.
Create access point groups
Select Menu > Control panel > Settings and
Connection > Destinations.
Some applications allow you to use access point groups
to connect to a network.
154
Settings