Nokia FastMile - Figure 19 Location of Physical Interfaces on the Nokia Fastmile Outdoor Unit

Nokia FastMile Outdoor Unit User Manual Installation procedure
Issue: 01P03 3TG-00088-AAAA-TCZZA 57
Confirm that the location is suitable for considerations within the home, and that the Ethernet
cable (with or without an additional Cat5e shielded Ethernet cable attached) can be safely
and securely run though the wall and inside the home from the Nokia FastMile Outdoor Unit
to the indoor unit or PoE injector or to the prospective indoor unit or PoE injector location.
The indoor unit can be a residential gateway such the Nokia 7368 ISAM CPE A-020W-A; the
PoE injector must a Nokia-approved PoE injector.
10 Mount the Nokia FastMile Outdoor Unit and make connections as described below.
As part of this step you will be working with most of the interfaces shown in Figure 19.
Figure 19 Location of physical interfaces on the Nokia FastMile Outdoor Unit
i Unpack the following from the shipping package:
• Nokia FastMile Outdoor Unit
• wall-mount bracket; note that the wall mount-bracket is shipped attached to the
mounting plate with three fasteners
• two screws for attaching the mounting plate to the Nokia FastMile Outdoor Unit
ii Separate the mounting pl
ate from the wall-mount bracket and save the three fasteners
for securing the mounting plate to the wall-mount bracket later on in this step
iii Use the two supplied screws to attach the mounting plate to the back of the Nokia
FastMile Outdoor Unit as shown in Figure 20.
SIM slot
Ground point
Ethernet Cable
LED Reset
button
27898