AG 5500
System Administration 227
Importing the Factory Defaults {Factory}
This procedure shows you how to replace the current configuration settings with the settings
that were established at the factory.
1. From the Web Management Interface, click on System, then Factory. The Factory
Configuration screen appears:
The factory default configuration does not include the network settings. The
network connection will be lost if this “import” function is performed. To avoid
a prolonged service interruption, perform this procedure from the Command
Line Interface via the serial port.
If you restore the factory default configuration settings, you will no longer be able
to access the AG 5500 remotely. However, you always have the option of using the
“import” function to restore system configuration settings from the archive file.
You will need to reboot the system for some of the imported default settings to
take effect (especially DHCP).
ag5500_userguide.book Page 227 Tuesday, June 5, 2007 7:31 PM
To Next Page
Loading...
