AG 5500
1
Installing the AG 5500 29
Installing the AG 5500
This chapter provides installation instructions for the hardware and software components of the
AG 5500. It also includes an overview of the management interface, some helpful hints for
system administrators, and procedures for the following tasks:
z Unpacking the AG 5500
z Powering Up the System
z Logging In to the Command Line Interface
z Establishing the Start Up Configuration
z Logging Out and Powering Down the System
z Connecting the AG 5500 to the Customer’s Network
z Establishing the Basic Configuration for Subscribers
z Archiving Your Configuration Settings
z Installing the Nomadix Private MIB
See also “Installation Workflow” on page 31.
Once you have installed your AG 5500 and established the configuration settings,
you should write the settings to an archive file. If you ever experience problems
with the system, your archived settings can be restored at any time. See
“Archiving Your Configuration Settings” on page 55.
Nomadix AG 5500
ag5500_userguide.book Page 29 Tuesday, June 5, 2007 7:31 PM
To Next Page
