AG 5500
32 Installing the AG 5500
Powering Up the System
Use this procedure to establish a direct cable connection between the AG 5500 and your laptop
computer, and to power up the system.
1. Place the AG 5500 on a flat and stable work surface.
2. Connect the power cord.
3. Connect the DB9 serial cable between the AG 5500’s “serial port” and your computer.
4. Turn on your computer and allow it to boot up.
5. Turn on the AG 5500.
connect the serial cable here
ag5500_userguide.book Page 32 Tuesday, June 5, 2007 7:31 PM
To Next Page
