AG 5500
74 System Administration
Defining Automatic Configuration Settings {Auto Configuration}
The AG 5500 allows you to define parameters to enable the automatic configuration of the
system. See also, RADIUS-driven Auto Configuration.
1. From the Web Management Interface, click on Configuration, then Auto Configuration.
The Autoconfiguration Settings screen appears:
2. Enable or disable Autoconfiguration, as required.
3. If you enabled Autoconfiguration, you must enter the following information into the
corresponding fields:
z RADIUS Authentication Name
z RADIUS Password
z Confirm Password
4. Click on the check box for Reboot after changes are saved? to reboot the system when
you submit your changes.
5. Click on the Submit button to save your changes, or click or the Reset button to reset all
data to its previous state.
ag5500_userguide.book Page 74 Tuesday, June 5, 2007 7:31 PM
To Next Page
