AG 5500
Installing the AG 5500 33
Logging In to the Command Line Interface
Use this procedure to initialize the system and log in to the AG 5500’s Command Line
Interface (CLI). The character-based CLI is used at initial start-up.
1. Start a HyperTerminal™ session to connect to the AG 5500. Use the following
HyperTerminal settings:
2. When connected to the AG 5500, a login prompt appears on your screen.
The default login user name is “admin.” The password is “admin.” Login names and
passwords are case-sensitive.
3. Enter admin when prompted for a user name and password. The AG 5500 Menu appears
when you have logged in to the AG 5500’s management interface successfully. If this is
an initial installation which requires the AG 5500 to receive a license key from the
Nomadix License Key Server, you must accept the Nomadix End User License
Agreement (EULA).
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control None
ag5500_userguide.book Page 33 Tuesday, June 5, 2007 7:31 PM
To Next Page
