AG 5500
80 System Administration
Managing the DHCP Service Options {DHCP}
When a device connects to the network, the DHCP server assigns it a “dynamic” IP address for
the duration of the session. Most users have DHCP capability on their computer. To enable this
service on the AG 5500, you can either enable the DHCP relay (routed to an external DHCP
server IP address), or you can enable the AG 5500 to act as its own DHCP server. In both cases,
DHCP functionality is necessary if you want to automatically assign IP addresses to
subscribers.
1. From the Web Management Interface, click on Configuration, then DHCP. The DHCP
Settings screen appears:
ag5500_userguide.book Page 80 Tuesday, June 5, 2007 7:31 PM
To Next Page
