AG 5500
68 System Administration
10. If the Credit Card Service is enabled, enter the information for the following fields:
z Credit Card Server URL
z Credit Card Server IP
z Merchant ID (a valid ID issued by the credit card reconciliation service provider –
Authorize.net or Chainfusion).
11. Enable or disable the SIM Compliant feature, as required. With this feature enabled, you
can change the transaction key at your discretion. To change the transaction key, simply
enter the key in the
Change Transaction Key box, then re-enter the key in the Verify
Transaction Key box.
12. Enable or disable Smart Client Support, as required (if enabled, your license key must
support this feature).
13. You can assign a session idle timeout parameter for subscribers (see following note). To
assign an idle timeout, simply enter a numeric value (in seconds) in the
Subscriber Idle
Timeout box (the default is 1200).
14. If you enabled or disabled SSL Support on this screen, you must click the check box for
Reboot after changes are saved? (the AG 5500 must be rebooted every time the SSL
Support feature is enabled or disabled).
15. Click on the Submit button to save your changes, or click on the Reset button if you want
to reset all the values to their previous state.
The SIM Compliant option refers to Authorize.net's Simple Integration Method.
Subscriber Idle Timeout does not apply to RADIUS and Post Pay PMS
subscribers.
ag5500_userguide.book Page 68 Tuesday, June 5, 2007 7:31 PM
To Next Page
