AG 5500
72 System Administration
2. For Configurable Ports, enter a Telnet Port and an HTTP Port.
3. Enable or disable administrator access to any of the following interfaces:
z Telnet Access
z Web Management Access
z FTP Access
z SFTP Access
z SSH Shell Access
4.
Enable or disable subscriber-side interface blocking for any of the following interfaces
z Telnet Access: enables/disables blocking of Telnet access from the subscriber-side to
the NSE Telnet interface. Default setting is enabled.
z Web Management Access: enables/disables blocking of Web Management access
from the subscriber-side to the NSE WMI. Default setting is enabled.
z FTP Access: enables/disables blocking of FTP access from the subscriber-side to the
NSE. Default setting is enabled.
z SFTP Access: enables/disables blocking of SFTP access from the subscriber-side to
the NSE. Default setting is enabled.
z SSH Shell Access: enables/disables blocking of SSH shell access from the
subscriber-side to the NSE CLI. Default setting is disabled.
5. Click the check box for Access Control if you want to enable this feature, then click on
the
Submit button to save your change.
If you enabled Access Control, administrator access is restricted only to the IP addresses
shown under the “Currently Access is Permitted for IPs” listing. If you want to add to or
remove IP addresses from the list, go to Step 4 through Step 8.
6. To add an IP address (or range of IP addresses) to the list, enter the “starting” IP address in
the
Access Control Start IP field.
Blocking or unblocking interface access will terminate the current session.
Do not enable the blocking of all interfaces without setting up and enabling
SNMP. Enabling the blocking of all interfaces and disabling SNMP will
completely block access to the AG 5500 administration interface. For
assistance, contact Nomadix Technical Support.
The Access Control list can contain up to 50 (fifty) valid administrator IP
addresses or up to 50 (fifty) ranges of IP addresses.
ag5500_userguide.book Page 72 Tuesday, June 5, 2007 7:31 PM