AG 5500
System Administration 83
12. Enter the DHCP Lease Minutes.
13. Select Public Pool or Private Pool, as required.
14. If required, make this an IP Upsell Pool and/or the Default Pool by checking the
appropriate boxes.
15. When finished establishing your DHCP Pools, click on the Back to Main DHCP
Configuration Page
to return to the previous page.
16. You must now reboot the system for the new settings to take effect. Click the check box
for
Reboot after changes are saved? then click on the Submit button to save your
changes and reboot the system, or click on the Reset button if you want to reset all the
values to their previous state.
When the system restarts, DHCP is enabled and configured. Skip the remaining steps in
this procedure and go to “Managing the DNS Options {DNS}” on page 84.
A “public” IP address will not be translated by DAT.
Do not allow pools to overlap.
ag5500_userguide.book Page 83 Tuesday, June 5, 2007 7:31 PM
To Next Page
