NorAM 65 E T4 FINAL - Every 500 Hours or 3 Months; Hydraulic Oil Filter - Change

NORAM 65ET GRADER
4-27
Lubrication and Maintenance - Grader Components
4
Every 500 Hours or 3 Months
EVERY 500 HOURS OR 3 MONTHS
Hydraulic Oil Filter - Change
Change hydraulic filter when oil is cool.
1. Loosen fill cap
(1) to release pressure.
2. Remove bolts
(2) attaching filter cover (3) to oil tank.
Carefully remove cover, spring, cap and o-ring from top
of tank.
3. Remove element
(4) and discard according to federal,
state and local regulations.
4. Inspect o-ring for cuts, tears or deterioration. Replace,
if necessary.
5. Install new element, o-ring, cap and spring. Secure
cover over spring. Torque cover bolts to 47–53 N•m
(35–40 lb-ft).
Hot fluid can burn. Fluid is under pressure. Turn cap slowly to relieve pressure
before removing.
1
3
2
4